Tag Archives: Side project

Jeenode: Interference

Posted on 2012/12/16 by rt

Because of the previous post, I decided to  test a bit more. To see if I could physically move the board to reduce interference. So I connected the Arduino with the attached RFM12B radio module. The one using the Sparkfun … Continue reading →

Posted in Arduino, Electronics | Tagged , , | Leave a comment

RFM12B: Dealing with radio interference

Posted on 2012/12/16 by rt

This is a screenshot from the serial monitor of a Jeenode (Arduino compatible) connected to my computer. It runs a program that will listen to incoming radio messages through its RFM12B radio transceiver. In this window, you can clearly see too … Continue reading →

Posted in Arduino, Electronics, MP | Tagged , , , , | Leave a comment

Side Project: Data Stucture – Application

Posted on 2011/08/02 by rt

If you were patient enough and read through the two previous posts on this subject, you might be wondering how this applies to the PU-2 pedal board in practice. Even if you were not patient enough, here’s how the data … Continue reading →

Posted in Arduino, FCB1010, Pedal board, PU-2 | Tagged , , , , , | Leave a comment

Side Project: understanding cheap Rotary encoders

Posted on 2011/04/14 by rt

Seven whole days! That’s how long I had to work to finally get my rotary encoder to work with the Arduino! The idea is to be able to quickly select a preset on a guitar pedal board using a rotary … Continue reading →

Posted in Arduino, Pedal board | Tagged , | 1 Comment