Category: Uncategorized

  • Detailed design of 3D print piece example: Sink Strainer

    This post is about the detailed design of a 3D printed simple kitchen sink strainer. I tried a few existing models but none fitted properly and none worked perfectly. This is an article about all the details needed for such a simple piece. Initial Research Looking at the strainer that came with the sink, I…

  • Dishwashing a 3D model printed with PLA plastic

    I created a simple spoon/utensil holder to use while cooking. It’s a very simple model that is printed with PLA. I decided that washing it by hand was a bit tedious so I placed it in the dishwasher. I knew that it might distort because it was printed with PLA material, which is known to…

  • Behringer FCB1010 – Alternate power source

    Behringer FCB1010 – Alternate power source. The Behringer FCB1010 has an internal power supply that is fairly easy to replace. There are a few options available: I will detail these options. Open your FCB1010 by removing all the screws under your pedal board. Note that there are two screws holding the transformer and one screw…